Blower motor resistor ???

[sandrooney]

Anybody ever have to replace the blower motor resistor on their Thor Axis?

I installed a new blower motor and now it only works on high. I did some research found that it is probably the resistor. Anybody know where it's located?
Thanks a lot
Kevin

[John & Diane]

I'm not sure where the resistor on your Axis is, but on our Windsport (F53 chassis) it is on the bottom of the housing right next to the blower. When I replaced our blower motor and blower wheel it was visible in the open housing. On ours it would be fairly simple to change once I got this old body on the floor. Looked like one wire to unhook and two screws to remove. Good luck, hope it's easy to reach.

[OldWEB]

J & D is correct, 99% of the resistors are mounted in the blower housing, it is the 'thing' with the wires next to the blower motor. Mounted so it uses the air movement from the fan to keep the resistor part cool. Usually the connector overheats and fails, but buy both as a kit. Autozone


Stay cool

[sandrooney]

Thanks a lot. I will check it out. I hope it's easier than the fan motor, it was a PITA.
Thanks again