Low voltage auto levelers

[rdd001]

Yep that is what I thought and that is why I posted my reply. I wish I would have seen your post a little early. Like I stated in my previous post that will be the first thing I check in the future if any electrical problems. I was stuck for about 90 mins trying to leave my campsite before I figured it put. Glad you got it resolved.

[SuperD]

Know it was frustrating but glad you were able to solve the problem!!!

[George Ryan]

Ours still isnt fixed. Now they are saying it needs a new control panel, which is on back order. So much for our summer. To bad Thor wont pay all my cancelled reservations and gas back and forth.

[schreinertms]

I have had the same low voltage issue with my jacks since new. I found the way around it is to rev the engine idle a bit and then operate the jacks. Once the jacks start to deploy, let up on gas pedal to idle. Works every time. The first time this happened, called Lippert and they wanted me to check voltage at the leveler pump but I did not have a meter. I cleaned the battery terminals and then the jacks worked fine. The next time it happened I tried the engine rev and that worked.

[George Ryan]

Thanks for the info.

[hpycmpr]

Hi, can you tell us where you found the reset button that fixed your problem? Was it in the house battery compartment? Thanks

I run into the same problem with low voltage, but after replacing the batteries, it hasnt happend again. Those are great tips regarding the voltage.

[schreinertms]

Yes located in the house battery compartment. Looks like the attached pic.