Thor Ace Lipper Leveling System Not Working

[dscudder]

My leveling system is not working correctly. After having to do a manual retract and then replace a fuse I reset the hydraulic valves. Now when I do either automatic or manual leveling all four pads come down simultaneously. In automatic they continue until all four tires are in the air. In manual any of the four buttons cause all four pads to come down together. How do I reset the system so that it operates correctly again

[WillowRun]

first welcome to the world of Lippert Jacks!! lol....well, find your controller- usually first bay behind driver side near the slide controller but separate...unplug....wait about a minute and re plug.then turn on generator....then engine then engage break...if i you turn on at keypad and powers up and you don't have an error, look in the owners manual for calibration to level- there is a sequence of buttons to push on the pad to set it back to square-BUT- and this is big---you MUST be almost already perfectly level.........if after you have unplugged the controller though and you have an error, you have another issue. AND check your ground wire to it- ours was not connected and service said it actually just scrambled the controller after 3 tries so they replaced it. Works perfect now....also, if you call lippert Cust Service they are VERY helpful as far as tracing down and telling you over the phone-just have your portable phone in hand as you run around the coach with him!!

[dscudder]

Thanks! I'll try the sequence when I find a level place!