Go Back   Thor Forums > steve76
Click Here to Login
Conversation Between steve76 and pjciii
Showing Profile Comments 1 to 2 of 2
  1. pjciii
    11-19-2017 11:17 AM - permalink
    pjciii
    i did a little off center. it fits up against the wall like the original table, but when i use the outside table leg it can rotate 360 degrees. gives me options. i also cut a 3/4 inch piece of plywood 16 X 28 that i can lay down so it makes a U-shaped dinette. used one of the pillow covers and stuffed it full of memory foam to make a seat cushion that matched the dinette. had to cut some of the inner stitching. it works ok and matches dinette cushions or cut the bed cover that came with it to make cushion. i don't use that anyway. also thank you for the link to the swivel base. going to ask Santa for it and see what happens. it in on the DW's side anyway..

    pstrick
  2. steve76
    11-18-2017 01:00 PM - permalink
    steve76
    Thank's Patrick. did you off center it where attached to table so it swings like you describe? Swing against side wall and then 180* opposite?
Disclaimer:

This website is not affiliated with or endorsed by Thor Industries or any of its affiliates. This is an independent, unofficial site.




All times are GMT. The time now is 06:20 AM.


Powered by vBulletin® Version 3.8.8
Copyright ©2000 - 2019, vBulletin Solutions, Inc.
Content Relevant URLs by vBSEO 3.6.0 PL2