LovemyClassC

My Freedom Elite has the gas cap exposed(ie. not behind a hatch door). I have a locking gas cap but wish to cover it with a locking hatch door. I found one at RV Parts Center on line. Abt $40. It is Stainless Steel. I believe I would need to add some plastic shims to extend it some. Has anyone ever done this? Thank you
https://www.rvpartscenter.com/shop-b...-979010-detail

My Freedom Elite has the gas cap exposed(ie. not behind a hatch door). I have a locking gas cap but wish to cover it with a locking hatch door. I found one at RV Parts Center on line. Abt $40. It is Stainless Steel. I believe I would need to add some plastic shims to extend it some. Has anyone ever done this? Thank you
https://www.rvpartscenter.com/shop-b...-979010-detail

Good afternoon: Question? Has anyone ever entertained or completed relocating their sewer outlet from the drivers side rear to the rear bumper area? I would suspect I could gain an inch or two of height and reduce the likeliness of scrapping the end cap from the sewer outlet when exiting drive entrances.

I am a relatively new Thor Freedom Elite 2018 F22E owner. First question: The Thor MC information talks about a Battery Isolation Manager and shows a picture of what it is expected to look like. Also says it should be near the house battery located at the entrance step. I have looked high and low and even very low, on my back underneath the RV and do not seem to see it. Any ideas of where it should be? Thank you in advance.