Thor Forums

[Ubides]

Originally Posted by Ubides

Sure

Here is a pic of what I did to make the same lock on my RV remote. Purchase a SMALL MICRO DOOR LOCK Actuator Motor 2 Wire 12V DLSM2. Installed it as you see in the picture, it’s a 2 wire unit and route the cable to the drivers side hinge side and attached to the Drivers remote lock and added 2 on and off switch to turn off the RV driver and passenger side so the remote will open only the cabin door only .
Switch one activate all doors.
Switch two activates only the cabin door.


Good luck hope this is helpful l know it was a lot cheaper