Thor Forums

[doubravsky]

Hello all,

I've got a four winds 31W with the big slide. It works fine in normal circumstances, for example when the campsite is relatively level to start with. But when there's enough of a grade to cause front or rear wheels to lift off the ground when leveling (not a lot but some), the jacks will extend until it's nearly level, and then make noise for a bit without the jacks moving, then a beep will sound, and the message "low voltage error" will come on the controller.

After turning off the leveler, I can reset the breaker under the rig near the house batteries, and it will work again.

Seems like the problem happens at the upper end of the jack's travel. I took it to local dealer and they were "unable to replicate" the problem. I think they didn't put it on enough of an angle. Hydraulic fluid is full.

Any suggestions or ideas?

thanks!

Dave