Quote:
Originally Posted by bevedfelker
In the early Axis/Vegas model years to replace the chassis battery the recommended method was to remove the dash desk and then cut through the plywood dash top in a designated area to access the battery from above. In searching the forum for replacing the Axis/Vegas chassis battery on 2014 or 2015 models I found that owners Chucke and Gunner3 describe their experience in changing their battery. I included a description and pictures in the owners' manual I compiled that is available here on the forum.
What I have not been able to find is how to remove the dashtop desk. In Chucke's description he talks about removing 12 screws but I do not see where those screws are. I'd appreciate if someone could post a description on how to remove the desk. If anyone has pictures that would also be helpful.
Thanks.
|
I had a 2017 Axis 25.2. Soon after we got it I found I could not service the battery. Remove the screws on left and right fold- back table, then remove all screws holding the plastic pan. You will see a 1/4" plywood board. Go to Lowe's and buy 2 hinges and 3 L brackets. Before you cut thru the tabs holding the board in place, center and attach the hinges on the left side. Then cut the tabs and lift the board. There is a heat resistant membrane. You can reattach if you choose. After filling battery with water or change out, use L brackets on all 3 sides to hold in place.... Bob Trice
Thor Forums
