Quote:
Originally Posted by cvflowe
Nice Bolt! Do you have to do anything special to tow it? For example, disconnect battery?
|
When towing with a dolly you have to disconnect the - terminal of the 12V battery (according to the owner's manual):
Quote:
Tow the vehicle with the two rear wheels on the ground and the front wheels on a dolly.
To tow the vehicle from the front with the rear wheels on the ground:
1. Put the front wheels on the dolly.
2. Shift the transmission to P (Park). See Shifting Into Park P 206.
3. Set the parking brake.
4. Secure the vehicle to the dolly
5. Follow the dolly manufacturer's instructions for preparing the vehicle and dolly for towing.
6. Release the parking brake.
7. Turn the vehicle off.
8. Open the hood.
9. Wait two minutes.
10. Disconnect the negative (-) terminal connector from the 12-volt battery.
11. Close and latch the hood.
|
Might have to install a knife disconnect on the - terminal of the Bolt!
The interesting bit in there is the "wait two minutes" must have to wait for some module to time out and power down automatically.