I need to check shore power again when I get near a place where I can plug in, but if I remember right, shore power gives me the high 13v range on the house battery. I ran this flow chart and it all checked out as it should. But when I step outside and take voltage directly from the battery, I get 12.7-12.9vdc. I hope I am explaining this in proper terms.
I am attempting to attach the flow chart. Hopefully it worked
Low current ---Blown Fuses - NO--- so I removed the polarity fuses and checked DC output. It was at like 13.28 vdc. When plugged back in, I checked the BLUE wire voltage and it was 13.3 vdc as well. But when I take voltage off the 'C' and 'D' wires, it reads what I see on the battery outside.....like 12.7-12.9vdc. Then after powering off gen, the resting voltage is around 12.5vdc. I'm at a loss.
http://www.thorforums.com/forums/att...1&d=1536893631