After I replaced my factory fan, see photos on Ryan’s (Rynosback) thread, I started worrying about the factory stapling of the plywood panel. My fan seemed to be firmly attached. I took the fan down and screwed angle brackets onto the 2x4s running fore and aft on either side of the recess in the ceiling. I then screwed the angles onto the plywood that is stapled above. This should keep the fan from falling. I would like to take credit for the idea, but it was suggested on a response on Ryan’s thread.
John
__________________
Full Timers
2016 39DBRS3
2015 F350
|