Quote:
Originally Posted by Peterrrr
It would be the converter that your changing. Just curious why you went with the 9200 series and not the 4600 series. The 4600 should fit right into the old converter slot of the WFCO. Your going to keep the WFCO AC and DC distribution parts of your power centre. Would it not have been an easier install to go with the 4600? The 9200 from what I read is recommended to be installed horizontally. Are you going to have enough room in the area where your power centre is? From my readings I believe the 4600 has all the same featu  tres and the option for the remote pendant.
I also noted that Progressive has warnings on their site about internet sellers selling units without serial numbers. Make sure you get one.
Look forward to your pictures. |
No, the WFCO model 9855 deck mounted converter
I had was a wall mounted unit similar to the 9260 making replacement a matter of unplugging the power cable, removing the ground wire along with the positive and negative wires, then mounting 9260 in the same spot and reattaching the wires and plugging power cable back in turning on the power, voltage check and unit was putting out 13.7 vdc...unit came with a manual plug in charge wizard, not sure if I will plug it in or just relay on built in charge wizard....I also made sure to get a retail model with serial number, I had heard the same thing...
Thor Forums
