Quote:
Originally Posted by TurnerFam
do you have the 'remote' version, where your Magnum panel controls it, or is it the manual version, where you have to physical rotate buttons on the module?
the 'test' option is to allow it to automatically prime, crank, and run for 30 seconds before automatically shutting off.
If this is not working, you probably have one end of the communications wire that is not seated properly, or the module itself is not receiving 12v power, with a green light.
|
It’s manual. There is a enable and status control in the cab. Then the controls where you rotate buttons in the bay. I’ve attached photo of settings