Thor Forums

[flipper003]

Analoguy - on my Thor Axis, all I had to do was take 2 screws off a panel above and to the rear of the radio. Take off the rubber pad on top, remove the 2 screws,
and lift and slide the panel towards the front of RV - should come right out. Then
you get a bird's eye view of all the wiring crammed in there (plenty). If you look
at the rear of the unit lower left, there is a black plug-in wire which is the power.
Trace away from the radio and you will find the fuse in a small black cylinder. It
unscrews and there is a small 5 amp fuse inside. Mine was ok. Once I got the
RV out of garage for a short test run my wife got the thing working. She had to press and hold for several seconds for the thing to turn on - I was just pressing
and releasing like one would normally do. Go figure and good luck. Hope this helps.