Thor Forums

[bevedfelker]

Do the easiest thing first. There might be air in your lines and the furnace ignitor safety circuit times out.

Try this:
1 - Be sure there is propane in the tank and the main valve is open.
2 - Open the stove top cover and light one of the burners. Then light a couple more burners and let run for about a minute.
2 - Turn off stove burners and close up stove.
3 - Now put the thermostat to heat and set the temp for about 68 or 70 degrees. The furnace fan should start immediately. In about 5 seconds the sound of the furnace fan running should change and you'll hear a deeper sound (that's the burner). You should now be getting heat.