Quote:
Originally Posted by 10scDust
Glad Thor is taking care of you.
What is the Girard hot water part?
My hot water trips the breaker when put on 110vac.
What is it about yours?
|
Hello Rusty.....
I have the Girard GSWH-2 Tankless Water Heater. I was getting an E5 error message, which indicates the blower is not running.
The troubleshooting indicates that it is either the blower motor itself or the main control board. I had the proper voltage on the control board so it looked like the motor. Thor sent me both parts and it turned out to be the motor.
I have seen a few guys post about a similar problem to your breaker tripping or no AC operation at all. I think some of the guys reported the wiring to the water heater was the issue with wiring and poor connections. I think a couple guys posted pictures of melted wiring as a result. Might be worth a look if you can get to the area where the AC connects into the heater.
I appear to be in the lucky minority with respect to the wiring in my rig. So far I have not found a single wire nut in my 2018 Outlaw 29H. They used Wago 221 Lever-Nuts instead of traditional wire nuts. They make for a much cleaner and secure installation and make it very easy to make wiring changes if needed.
Thor Forums
