Clay, I pulled the toilet today and didn't find any leaks. I have one of those push button flush toilets. Last winter I had to replace the valve for the water because it was not shutting the water off after the flush. At the same time I replaced all the seals including the O ring that goes down the floor drain. Its a different set up then the regular toilet seals. Anyway, all I could find was the main part of the electronics and flush tube piece was loose a little on the ceramic toilet. When I installed it I was afraid to tighten down the three bolts to much and break the ceramic holding tabs. I tightened them down more and its gone a hour now without leaking. We were just using a jug of water to flush with but now I've got the water line turned on and have our fingers crossed.
I know this whole thread I started probably doesn't make sense, especially if its just the toilet.