Quote:
Originally Posted by John & Diane
What year is your MH? I looked under or 2015 Windsport 27K (passenger side) and only see 3 points where the lamp assembly is attached to brackets that appear to be molded into the front cap. In ours it appears after unbolted it would pull out along the outside wall of the MH and then drop down. The 3 mounting points I see are located top center, bottom center, and outside wall edge. There may be another mounting point that I can't see or feel on the inside edge. Our MH is parked where I can't get to the drivers side corner. Our MH uses headlight assemblies from 2007/2008 Tahoe according to the drawings I got from Thor.
|
Mine is a 2015 34E. That's what I'm finding on the driver side too. The problem is I'm having a hard time finding space to get the light out . There is framing under and on the side that leaves no space. Next I'll try to remove the back aluminum plate so the cables that run between the light and light frame.
If I can at least move the light enough to get my hands in to do the repair to the fibre glass I'll be ok. I'd like to be able to get a grinder in to clean up the rough fiberglass and install a support block covered with fiberglass Matt. The re gellcoat the out side. Thanks for the response