Booster Installation Complete
I installed the booster today. Since my generator is drivers side rear I connected a wire to 12VDC lead coming into the generator from the batteries. I was able to run the wire through an existing electrical grommet and I wrapped the wire with automotive conduit. There was an existing ground on the frame about 3 inches from the generator. I connected a ground wire to that and used it for my switch and the signal booster ground. I then ran a lead from the switch to the booster. Switch on, booster on; switch off, booster off. The switch I installed is a lighted toggle switch. I mounted the booster itself to the underside on my electrical storage compartment frame with the antennas facing down. Installed where it is makes it visible when I am connecting or disconnecting the shore power so I'll remember to turn it on or off when needed.
Working slow it took me about 2 hours to complete the install.
Getting ready to head out on a five day trip so I'll check my tire pressures tomorrow or Tuesday and install the sensors at that time.
__________________
Dave
US Army (Ret)
2020 Entegra Accolade 37TS
2019 Jeep Grand Cherokee Trailhawk (Toad)
FMCA - F432054
|