Thor Forums

[wogden]

Well we are back from a 9000 mile road trip! Can't say that it was our best trip from a "worry standpoint" with this new RV.
Would like to get some input from other forum members on several issues.

Our water heater has two switches on the control panel. The obvious one for propane and one for electric. The propane works as one would expect, however the electric does not. A rep said there was a switch on the heater that needed to be turned on. The manual says that you can run both at the same time to increase the heating time. There is no such switch so I removed all the cushions and seat platforms to see if the "switch" was under the seats near the tank. I can find no such switch and I can not find any 120 vac wiring going to the heater unit. Any ideas?

Our slide which has been used maybe twenty times during the trip is not returning to the rested position correctly. The rear comes in first and rests against the body as one would expect. The front catches up a bit later and then rests against the body as it should. The total travel with the front portion "in the catch up mode" is around 2 inches. As you drive the Rv the front portion of the slide releases a bit and sets around 3/4 of an inch away from the resting position. At this point the movement of the coach causes the slide to emit rubbing noises that is very annoying. You can see where the slide is rubbing against the main body when it has released a bit.
Anyone having similar issues?

Our cabinet hinge pins keep falling out. We have reinstalled them but they fall out from the result of road vibration. Stupid but again annoying. Is there a fix for this?

Our cabin heater unit works but the one and only duct which is by the dinette is dead. No air flow going or coming. Thought it may be a cold air return but it appears not to be. The ducting is run into the heater cabinet and appears to be hooked up. Anyone have any experience with this type of heating unit?

I know that I can take this to a dealer. Our nearest dealer is 50 miles away and although I have called them I have not received a call back from them....yet!

And for those that remember my "vibration thread" I will add that we are still fighting those issues as well. More on that later.