PDI went relatively well. Found a few minor issues which were corrected on the spot and then a couple of issues after getting the unit home. I have not tried out all of the plumbing mechanicals as yet due to the sub-freezing temps but I'll get to them as soon as the temps rise.
What we found is:
Clearance light that is not working
One kitchen drawer latch, although it catches, it does not hold the drawer closed when going through road curves at speed
One bedroom cabinet has a piece of 1/8 inch veneer for finishing where one corner is not fixed in place
One slide seal has the bottom edge coming loose and needs to be resealed
Only one barrel key for the front clip
Only one key for the outside television compartment
The one thing that amazes me, and I see on the forum where others have the same issue, is why Thor could not label switches for slides and lights. Three light switched in the cabinet above the door and none are labeled as well as three slide switches on the control panel and none of them are labeled.
I hope to take it out for the shake down trip in the next week or two.
__________________
Dave
US Army (Ret)
2020 Entegra Accolade 37TS
2019 Jeep Grand Cherokee Trailhawk (Toad)
FMCA - F432054
|