Quote:
Originally Posted by dstankov
I do one thing further. When I turn the Jack power on I cycle through the LCD display until I get the reading for the battery voltage. I do not attempt raising or lowering the jacks until the voltage is over 12.7 VDC. Once the reading is 12.8 or higher I then raise or lower the jacks. No low voltage errors by adding this step and there were a couple of times when the reading was 12.6 or 12.7.
|
I didn't realize there was a voltage readout on the LCD display. However, I was told by a tech at LCI that leaving the RV plugged in or on a charger will not necessarily provide enough current at startup to operate the levelers. He told me to start the engine and let it idle for a few minutes before operating the levelers.