Quote:
Originally Posted by CSR
I responded to your other post, but thought I would drop it in here also (See below):
Are you referring to the confusing issue where the arrow to bring the slide IN does not display on the multiplex panel? If yes, another Aria owner shared this tip with me recently and it works perfectly.
STEP 1:
Press the spot where the arrow should be and you will get a "locked" message along with a flashing notice about the lift bed.
STEP 2:
WAIT approximately 20-30 seconds and the message will go away and the arrow will appear.
Works every time. I hope this helps.
|
I will also add that if you don't manually tilt the bed, the button on the control panel will do it for you! It is all automatic. Just push the bed button on the control panel and it will tilt the bed. Once tilted, the arrow comes on and then you can bring in the slide. Took me a few times to figure this out but it is pretty easy once you know.
The other trick I learned is that you have to have the engine accessory mode turned on before you can do anything with slides. (different than my fifth wheel).
Good luck!