Quote:
Originally Posted by scrubjaysnest
Thor e-mailed me a diagram but it was wrong. I couldn't find um within 6 inches of where they should have been. I used #12 SS screws 1 inch long. The screws were put in using an adhesive sealant. After that had set up used self leveling Dicor over the brackets and screws. No problems so far.
|
I had them send me the diagrams too, but I will still use a stud finder. I know there is one on each side of the roof vents so I will measure from there. I'm still debating the whole tilting aspect of it. More for being able to lift and inspect than anything but I may be over complicating things a little bit.