Axis / Vegas impressions and experience?

[garybuyit]

Docmike,
What is the brand of the fanless minicomputer?
Thanks,
Garybuyit

[DocMike]

Gary,

Somewhere on this Site I posted a listing/cost of what all I used (Modification to 2016 Vegas "Infotainment Center" on 7/9/15 or just search "Infotainment Center").

In the picture below you can see the set up. The Computer is a Quantum Byte.

http://www.thorforums.com/forums/att...1&d=1476566937

Doc

[RVegas]

Greetings ya'll.
I have a 2016 Vegas 24.1 and recently the bunk over cab started to grind the gears and track teeth. Took it to several dealers and was told that the whole system needs to be replaced - too much $$$. I took the matter on my own hands and it's not that of complicated system. Once I removed the bed and exposed the tracks and motors, I'm able to replace the tracks myself and the 6 teeth gear attached to the motors. I was able to find the gears online (amazon), but not the tracks. Tracks are the same as upper tracks on the slide-out but shorter - 30 inches in length.
Has any Vegas owners experience the same issue and/or repaired the over cab bed system? Any advice/idea is much appreciated - thanx

[JamieGeek]

Originally Posted by RVegas

Greetings ya'll.
I have a 2016 Vegas 24.1 and recently the bunk over cab started to grind the gears and track teeth. Took it to several dealers and was told that the whole system needs to be replaced - too much $$$. I took the matter on my own hands and it's not that of complicated system. Once I removed the bed and exposed the tracks and motors, I'm able to replace the tracks myself and the 6 teeth gear attached to the motors. I was able to find the gears online (amazon), but not the tracks. Tracks are the same as upper tracks on the slide-out but shorter - 30 inches in length.
Has any Vegas owners experience the same issue and/or repaired the over cab bed system? Any advice/idea is much appreciated - thanx

Call Thor to get a part number and with that call an RV dealer and order the parts.

When raising and lowering the bunk do you hold the switch down for 3-5 seconds after full up or down? That re-sync's the motors (should also do that for the slide).