Large bedroom drawer - how?

[Unchartered]

Someone... (no need to name names here), didn't have that large bedroom drawer closed when he tried to put out the slide on his 2016 35c Hurricane.

It still works, but not like it used to. I'd like to take it out and straighten anything that might have gotten bent.. Anybody know how it comes out/apart?

[CHS]

If it runs on metal slide tracks, usually there would be a plastic clip on either side of the rail where the two sections connect. Either pull up or down on it to release the draw from the slide. Hopefully it justs pulled the one side off the track and has to be reset by removing and reinstalling the draw. You may have to hold both clips at the same time while pulling it out, oer one may re-lock, so you may need another person to hold the clip open on the opposite side. Good luck.

https://www.youtube.com/watch?v=QTsIrBAV1dA&t=56s

[Unchartered]

Thanks, I'm familiar with those, but no tracks on these.

[CHS]

Look underneath and see if there is a clip in the very center. I had a set of draws that had that. You pull the draw out all the way then release the clip to take it all the way out.

[Unchartered]

That's it! Thanks.