Tuscany slide issue. No power to controller

rdojeeper · 10-28-2021, 02:25 AM

I have a new to me 2015 Tuscany XTE 36MQ. Rear driver's slide stopped working half-way out and now none of the four slides work. None of the slide controllers have any blinking or constant lights on them. The in-cab switch board shows "slide ready" but nothing happens when any buttons are pushed. None of the controllers have any lights even when hitting the mode button.

30 amp fuse is intact in the fuse panel. Is there anything I am missing??

lwmcguire · 10-28-2021, 01:31 PM

Tripped breaker near the hydraulic pump if you have hydraulic

rdojeeper · 10-28-2021, 02:38 PM

I found a 20 amp fuse/breaker for the Gen Slide by the levelers hydraulic pump and it's good too. Thanks for the info. I didn't see this fuse panel before!!

Still trying to figure it out!

lwmcguire · 10-28-2021, 02:55 PM

You should have a flag type breaker near the pump

50 amp or so

rdojeeper · 10-28-2021, 03:14 PM

Don’t see any 50amp breaker by the pump. You are referencing the hydraulic pump near the front driver side corner correct?

lwmcguir · 10-28-2021, 07:19 PM

Yes, there is a breaker in that hot lead to the pump, should in the compartment, as mine is

Verify you have power to the motor on the pump

rdojeeper · 10-28-2021, 10:35 PM

Well it turns out that it was a loose wire connection on the back of the fuse panel. Secured the connection and all good.

Thanks to lwmcquir for all the help!!

simidrm · 10-29-2021, 12:27 AM

Mine does that also and I found that if my lci panel times out and shuts off my slides will not work even though the slide ready light is on, I turn the leveling panel back on and slides work again

markaasmund · 11-01-2021, 02:28 AM

I have a 2016 36MQ and the slides are Schwintek , which are all electric, not hydraulic. I don't think the fuses/breakers for the hydraulic system will affect the Schwintek system. If yours are Schwintek look for a blown fuse in the master fuse panels in the outside compartment under the drivers side window. If not able to resolve, call Thor customer Assistance and they can likely walk you through a fix.

markaasmund · 11-01-2021, 02:29 AM

Oops, didn't realize you had a fix before I posted my reply. Glad you found the loose wire.

You may also like: