What toad braking system do you use?

[mrw]

The ready brake seems great but the cable would interfere with my steering column on Kia Soul

[bigben]

We had a BlueOx AutoStop installed initially - it sounds similar to the ReadyBrake. Gotta say after a descent into Ten Sleep, Wy form Buffalo, Wy I renamed the BlueOx AutoStop to Autojunk. It just didn't get the job done and our coach brakes were heating up badly. I like the ability to easily adjust the sensitivity of the system.

Just our experience.

[gkurts]

ReadyBrute Elite tow bar that has the ReadyBrake surge braking system. Love it. Following 'wermudfun' on YouTube (seriously excellent detailed videos on the entire install), I installed it completely on my own with minimal swearing. I also used the wiring harness / feedback relay to use the RV brake lights through the Jeep as well. I also connected to the brake controller wire (unused) to feed back a signal to a light on my RV dash so I know when the Jeep brake pedal is pulled by the system. This gives me good peace of mind that I don't have brakes locked up and that things are working as they should.

[mhbell]

Blue Ox Apollo with transmitter and receiver.

[PNTR10]

Thanks for all your inputs. I am learning a lot but still torn. ReadyBreak seems good because of it's simplicity and it seems like less to go wrong. So now I'm down to the Invisibrake and ReadyBreak. I think when I compare the total installed cost between the two systems it may sway my decision. I like the connect and go of both, rather than having to keep putting a unit in and out of our toad.