Hi. It was not the easiest swap but the 13” round sink has replaced the 10x13 oval.
Challenges were the new offset for the tail piece to mate to the new p-trap and the sink drain level being not too much higher than the drain pipe into the tank.
I’ll update specifics after I get organized.
Quote:
Originally Posted by Robertiverson
The 10” x 13” oval sink is recessed enough to where it’s hard to lean your head over it to brush, etc.
It looks like a 13” round might wiggle in an give much needed ‘catch’ for brushing.
Anyone try this yet?
|