Axis/Vegas Mods...1,2,3 Go.

[bevedfelker]

I use the noodle on the awning arm. Went to Lowes and bought the gray hot water pipe insulation. Cut is about 36" long and slit it up the length. Works great and does not allow framework to mar door. Zoom in on the front awning arms on the picture and you can see the foam when it is installed.

[vkb]

Originally Posted by BAHEMI

Yes for the awning frame

Check out Ed's post regarding the awning frame fix...that is the one I referenced earlier.

[mustang94]

ok hard to see is very well but here it is.... as you can see we used 3 shelves and not in the way at all...

[JamieGeek]

Mustang:
Looks like you have more room behind your toilet than we do in the Axis. Our toilet is up on a pedestal and the cabinet above it is lower than yours.

Wish we had the room for all three shelves. Looks great.

[Oneilkeys]

Add another 11' to your coach and you too can have three shelves.��

[Chance]

Originally Posted by Baddad53

My rig is in the shop for finishing touches of lastest mod...raising the area (40" x 82") where the recliners are going in. I took the dinette out and while sitting there on a temp chair I could see that the view was too low so I am raising the floor in that area even with the cockpit and putting in storage under it.

Also having the macerator put in.

Raising floor under dinette to cockpit elevation seems like an excellent idea. I would prefer going from a couch to a dinette (like converting a 24.1), but even there having the floor higher would allow passengers sitting on dinette to have a much better view of road. Sitting at same height also makes it easier to talk, etc.

What you are doing is similar to almost all ProMaster/Ducato Class Bs that have the driver and passenger seats at a higher elevation. Builders usually elevate the dinette so that all seats up front are at equal elevation. Mostly it's so they can eat on same table which doesn't apply to Axis; but it works out well regardless. Look forward to pictures.

[Chance]

Originally Posted by Oneilkeys

Add another 11' to your coach and you too can have three shelves.��

For an extra 1' added to length of 25.2, Thor could provide permanent shelves in form of much larger bathroom.

[mustang94]

Originally Posted by Oneilkeys

Add another 11' to your coach and you too can have three shelves.��

too funny....

[vkb]

Originally Posted by Oneilkeys

Add another 11' to your coach and you too can have three shelves.��

Oneil ! Did you get your HUD installed ?

[vkb]

Originally Posted by rvfigs

Yeah, I was working on a few mods over the weekend. Raised the passenger console with two cup holders for DW. Happy wife ...happy life.

I was actually trying to examine the space underneath the driver and passenger seat thinking about one or two slide out drawers. It seemed like a good place for more storage.

Would really like to see pictures of your project.

What did you do to the passenger side cup holder ? I, already, know after one short trip that this needs a modification...actually, on both sides. Ron has, even, resurrected his cup holder which he placed on the floor between the seats on our previous B+ ...

Back to your modification..please post a photo if you have time. thankyou K

[Oneilkeys]

Originally Posted by vkb

Oneil ! Did you get your HUD installed ?

Yes. That is on the Camping World thread under mods and updates #52-60.

[vkb]

Originally Posted by Oneilkeys

Yes. That is on the Camping World thread under mods and updates #52-60.

thankyou ! I missed that !

[Baddad53]

Originally Posted by Chance

Raising floor under dinette to cockpit elevation seems like an excellent idea. I would prefer going from a couch to a dinette (like converting a 24.1), but even there having the floor higher would allow passengers sitting on dinette to have a much better view of road. Sitting at same height also makes it easier to talk, etc.

What you are doing is similar to almost all ProMaster/Ducato Class Bs that have the driver and passenger seats at a higher elevation. Builders usually elevate the dinette so that all seats up front are at equal elevation. Mostly it's so they can eat on same table which doesn't apply to Axis; but it works out well regardless. Look forward to pictures.

Raised floor with seatbelts awaiting recliners. Two air ducts and 110 V outlet relocated. 81" x 45" area


Table/pedestal stage



Two storage areas

[ETS]

Would you share where you obtained the theater chairs and did you do the install?

[Baddad53]

Originally Posted by ETS

Would you share where you obtained the theater chairs and did you do the install?

they are wallhugger recliners -

Laxy Relaxer Lite Swivel Wallhugger Recliner, Lambright rv recliner, RV Furniture, Motorhome furniture, bus furniture, flexsteel rv furniture, lambright comfort chairs, rv seating, motorhome seating

They cost $1550 which includes shipping. Should get them next week.

[rvfigs]

Nice work! I would have preferred slide out drawers though. Carpet looks fantastic!

As I mentioned before, I wonder if it is possible to make one or two slide out drawers under the driver and passenger platform. There should be a big enough hollow cavity in there to make a least one nice slide out drawer.

I can't wait to see the final project completed. Love seeing these creative mods!

When in doubt...tinker tinker tinker!

[rvfigs]

My latest mod for the rambunctious water pump. You can still hear it, but the noise reduction is substantial.

[vkb]

Originally Posted by rvfigs

Nice work! I would have preferred slide out drawers though. Carpet looks fantastic!

As I mentioned before, I wonder if it is possible to make one or two slide out drawers under the driver and passenger platform. There should be a big enough hollow cavity in there to make a least one nice slide out drawer.

I can't wait to see the final project completed. Love seeing these creative mods!

When in doubt...tinker tinker tinker!

For someone making that Mod and wanting drawers..it would seem possible to purchase drawers from Home Depot/Lowes/Menards if you are not inclined to create them yourself !

[rvfigs]

Originally Posted by vkb

What did you do to the passenger side cup holder ? I, already, know after one short trip that this needs a modification...actually, on both sides. Ron has, even, resurrected his cup holder which he placed on the floor between the seats on our previous B+ ...

Back to your modification..please post a photo if you have time. thankyou K

I just made it taller and a bit longer to add two cup holders. I'm also adding a tilt door on the console because my DW wants some storage for small items.

[Baddad53]

Originally Posted by rvfigs

Nice work! I would have preferred slide out drawers though. Carpet looks fantastic!

As I mentioned before, I wonder if it is possible to make one or two slide out drawers under the driver and passenger platform. There should be a big enough hollow cavity in there to make a least one nice slide out drawer.

I can't wait to see the final project completed. Love seeing these creative mods!

When in doubt...tinker tinker tinker!

You can crawl under or look back from an open engine cowling to find out!!