Rear view camera suggestions

[Kvrgvr]

A thought for the 3 light rule. Find a light bar with 2 separate lights. Could install where one light is now. Save you from drilling holes.
Just a thought.

[16ACE27]

Originally Posted by Redsand

You got me thinking about the marker lights so according to my research DOT does in fact require three marker rethe the outsided lights 12" apart top middle on RVs. Thanks for the tip. I realky hate to add new holes but in this case unavoidable so I get to redo. Better to stay legal than to poke the bear right?

If there's no vehicle inspection I think I'd pass, claim the IR lights in the camera are red. I just remember some posts on this Forum about failing inspection due to burnt out clearance lights, couldn't remember if California was one of the states.

[Redsand]

Thanks again for ideas and comments. Another couple hours today and i restored the third light and relocated the camera just below it. Of course in that three inch span i encountered a structual aluminum frame to deal with but i managed to pass the wires to the 12v source and all is sealed and working (again).
The camera works so well in fact I'm considering a licence plate camera add on if the cost is reasonable. To be continued...