This past summer I installed a 190W Solar Panel and:
1) EPEVER Tracer MPPT Solar Controller. They have a Bluetooth option but I heard there were some issues, so I held off and am using the physical MT50 monitor.
2) Xantrex Freedom XC 2000W Inverter with their remote physical monitor and also using their Bluetooth app.
I'm a bit ignorant on the subject and still learning, but when I looked at the information coming from the two devices, it doesn't seem like a lot of data to do anything with. Voltage/Amps coming in, Voltage/Amps load out. A few settings here and there, but is there something I'm missing?
Is there a single monitor that can talk to both of these devices so I can see the "complete" picture all at the same time? Should I care? I'm not even sure this is a valid concern.