|
08-25-2018, 04:03 PM
|
#1
|
Senior Member
Brand: DRV
Model: Mobile Suites 38rssa
State: Alaska
Posts: 253
THOR #8691
|
Bedroom slide
Should the sides of the bed slide wood fascia be touching the wall when slide is fully extended?
__________________
2017 F350 CC 4x4 DRW Lariat 4.10
2018 MS 38rssa
|
|
|
08-25-2018, 04:07 PM
|
#2
|
Senior Member
Brand: DRV
Model: 39RESB3
State: Florida
Posts: 240
THOR #5499
|
Quote:
Originally Posted by f350ms38rssa
Should the sides of the bed slide wood fascia be touching the wall when slide is fully extended?
|
The sides do, but not the top of the slide!
__________________
Joe & Dottie Allen
2014 Mobile Suites Estates 39RESB3
2014 Ford F-450 DRW
|
|
|
08-25-2018, 04:20 PM
|
#3
|
Senior Member
Brand: DRV
Model: Mobile Suites 38rssa
State: Alaska
Posts: 253
THOR #8691
|
Ok, my sides aren’t touching, they are about 1.5 to 2 inches away.
__________________
2017 F350 CC 4x4 DRW Lariat 4.10
2018 MS 38rssa
|
|
|
08-25-2018, 04:35 PM
|
#4
|
Senior Member
Brand: DRV
Model: Mobile Suites 38rssa
State: Alaska
Posts: 253
THOR #8691
|
Wandering if I should try to adjust or wait I’ll be at the factory next month.
__________________
2017 F350 CC 4x4 DRW Lariat 4.10
2018 MS 38rssa
|
|
|
08-25-2018, 05:39 PM
|
#5
|
Senior Member
Brand: DRV
Model: 39RESB3
State: Florida
Posts: 240
THOR #5499
|
Quote:
Originally Posted by f350ms38rssa
Wandering if I should try to adjust or wait I’ll be at the factory next month.
|
Not sure what is involved with the adjustment. Haven't done that fix yet!
__________________
Joe & Dottie Allen
2014 Mobile Suites Estates 39RESB3
2014 Ford F-450 DRW
|
|
|
08-25-2018, 06:10 PM
|
#6
|
Senior Member
Brand: Thor Motor Coach
Model: Axis 24.1 KC's Big Box
State: Kansas
Posts: 2,171
THOR #3510
|
At one time, we went to the Schwintek site regarding a slide question. They recommend, if you think your slide is out of sync...to retract or extend wherever you are at this point...all the way keeping power switch on for 5 seconds after it has stopped moving...then go the other direction doing the same. We always follow this recommendation, every time we operate the slide. And...we Silicone our slides just about every use.
__________________
Ron & Kay n KC too !
2001 Scamp 13'
'KC's Little Box'
Jeep Wrangler TJ
|
|
|
08-25-2018, 06:18 PM
|
#7
|
Senior Member
Brand: Thor Motor Coach
State: Georgia
Posts: 2,585
THOR #4735
|
doubtful, as the slide has a SEAL between it and the wall, for water and weather!
__________________
the Turners...
two Campers, two Electric cars
former diesel pusher traveler
|
|
|
08-25-2018, 06:29 PM
|
#8
|
Senior Member
Brand: DRV
Model: 38RSSA
State: Wisconsin
Posts: 342
THOR #3221
|
The short answer is no. Wingnut60 (Joe) asked me that right after he purchased his new to him '15 RSSA. We have a 2015 38RSSA, the slide does not touch in the bedroom, ours never has and is sealed against the body just fine. We've had no trouble with the bed slide. We did however have a cable snap on the vanity slide.
Dan
__________________
|
|
|
08-25-2018, 09:05 PM
|
#9
|
Senior Member
Brand: DRV
Model: 41RSSB4
State: South Dakota
Posts: 313
THOR #5859
|
Depends on what slide and which end you are talking about. The part that is exposed and is visible has an extra piece of molding so that it does contact the wall. The opposite end does not.
__________________
George
Kerrville, Tx
2015 Mobile Suites 41RSSB4
2011 F350 Dually 6.7 PSD
|
|
|
08-25-2018, 10:46 PM
|
#10
|
Senior Member
Brand: DRV
Model: Mobile Suites 38rssa
State: Alaska
Posts: 253
THOR #8691
|
Mine is a cable slide, and there is a gap on both sides about 2 inches!
__________________
2017 F350 CC 4x4 DRW Lariat 4.10
2018 MS 38rssa
|
|
|
08-26-2018, 12:58 AM
|
#11
|
Senior Member
Brand: DRV
State: Texas
Posts: 678
THOR #3109
|
On my RSSA, the gap on both slides is to account for the cable/motor mechanisms.
__________________
2016 Tiffin 40QBH
2015 38RSSA--traded
2005 36TK3--retired, but it was a good one
2017 F450 KR
|
|
|
08-26-2018, 01:13 AM
|
#12
|
Senior Member
Brand: DRV
Model: 38 RSB3
State: South Dakota
Posts: 2,280
THOR #1658
|
Quote:
Originally Posted by Fulltimer50
Depends on what slide and which end you are talking about. The part that is exposed and is visible has an extra piece of molding so that it does contact the wall. The opposite end does not.
|
Mine looks the same way.
__________________
2016 DRV38RSB3
2015 Ram 3500 Regular Cab DRW CTD Asian trans 410 rear
|
|
|
08-26-2018, 12:17 PM
|
#13
|
Member
Brand: DRV
Model: 38RSSA MS
State: Washington
Posts: 53
THOR #5214
|
Quote:
Originally Posted by f350ms38rssa
Should the sides of the bed slide wood fascia be touching the wall when slide is fully extended?
|
Ours does not....2017 38RSSA
|
|
|
08-26-2018, 01:52 PM
|
#14
|
Senior Member
Brand: DRV
Model: 44' Santa Fe
State: Montana
Posts: 392
THOR #2053
|
Stick your hand in and feel around. You will find the motors and associated gear drives in there. It can't go any further because of these. Correct and proper setting.
Bill
__________________
If you are afraid to speak the truth out of fear of what others may think, it says a lot about who you are and what you will settle for.
|
|
|
08-26-2018, 02:51 PM
|
#15
|
Senior Member
Brand: DRV
Model: 39TKSB3 "Modified"
State: South Dakota
Posts: 1,838
THOR #1661
|
Have the factory adjust, the wood trim at the sides should touch the wall when extended.
__________________
|
|
|
08-26-2018, 04:16 PM
|
#16
|
Senior Member
Brand: DRV
Model: 44' Santa Fe
State: Montana
Posts: 392
THOR #2053
|
Depending on the year, model and type of slide. Not touching on several is standard because of the above mentioned items.
I'm not going to receive another hand slap for disagreeing with others again, am I? Or is this one ok because the mod friend has not posted yet?
Bill
__________________
If you are afraid to speak the truth out of fear of what others may think, it says a lot about who you are and what you will settle for.
|
|
|
08-26-2018, 06:34 PM
|
#17
|
Senior Member
Brand: DRV
Model: 41RSSB4
State: South Dakota
Posts: 313
THOR #5859
|
Perhaps the factory has chosen not to add the trim any more.
As you can see from my pic, even with the cable system, some are trimmed. Albeit only on the visible side.
__________________
George
Kerrville, Tx
2015 Mobile Suites 41RSSB4
2011 F350 Dually 6.7 PSD
|
|
|
08-26-2018, 08:47 PM
|
#18
|
Senior Member
Brand: DRV
Model: 39RESB3
State: Florida
Posts: 240
THOR #5499
|
On our 2014 the sides touch the body of the rig. The top trim does not. This is where the cables run and adjustments are made.
I believe it depends on the model you have, maybe not. We are in Hartford City, IN now and leaving Tuesday morning for Interstate RV in LaGrange for some work on rig. Wingnut (Joe), I will see you there. Planning on a factory tour on Wednesday morning at 10! Lot's of questions from a newbie on this rig for sure!
__________________
Joe & Dottie Allen
2014 Mobile Suites Estates 39RESB3
2014 Ford F-450 DRW
|
|
|
|
Posting Rules
|
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
HTML code is Off
|
|
|
|
|