Slide out gaskets

[f350ms38rssa]

My bedroom and vanity slide rubber gaskets are coming away fro wall. What is the best product to reattach them?

[rynosback]

Originally Posted by f350ms38rssa

My bedroom and vanity slide rubber gaskets are coming away fro wall. What is the best product to reattach them?

The sides, top, inside, outside? How about a pic?

[f350ms38rssa]

The bottom rubber gasket.

[Fulltimer50]

The bottom ones are only single. I make use of insulation for 1/2" pipe. Fits perfectly.

[f350ms38rssa]

The rubber is there, how is it glued or attached to the 5th wheel?

[Hunter11]

Below is what I used on ours. On ours the seal on a couple of the slides was trying to pull away from the side where it makes the turn at the top. Works very well.

https://www.homedepot.com/p/3M-17-6-...0-24/100151277

[Hunter11]

After reading through this again are you talking about the rubber seal that runs the under side of the slide out or the seals that run from the bottom up the wall and across the top to the other side? If it is the ones that run the width of the bottom of the slide then disregard the product I posted. I used that for the ones that are glued along the sides and top of the slide out.

[rynosback]

Originally Posted by Fulltimer50

The bottom ones are only single. I make use of insulation for 1/2" pipe. Fits perfectly.

I use the same thing as extra insulation plus it acts as a extra bug barrier.

[MS60ocb]

Reading your signature and having a 2018 model, isn't that a warranty problem?


Clay

[f350ms38rssa]

I'm not taking it in just for that. Just needs adhesive, just wondered what other people use.