2016 vegas 24.1 bed

[Doreen]

Attention Vegas 24.1 owners! It’s nice that I can use my back beds as either two twin size beds or use the center inserts and convert to one “king”. The trouble is that it is about a foot wider than a king and king sheets are too small. What sheets do you all use when you convert it to a “king”? I’ve had this Vegas since it was new and still haven’t figured out the solution. 🧐

[waynetaylor55]

Do you push the two mattresses together? The floor plan says they are 38" wide. A regular king mattress is 76" wide, so it should fit. A California King is only 72" wide. Maybe that's your issue?

[Doreen]

No. The two twins stay where they are and there are two cushions that you insert between the twin beds to make one bed which is 88 inches wide. Thanks for your response though.

[taylorbob1]

We use a King flat sheet and tuck in.
The rear measurement with filler pad is 74” x 92”
King flat sheet typically measures 110” x 114” (Cal King fitted sheet is 73” x 85”)

If you are a seamstress (like me, haha)...
- sew an elastic strap in each corner of the flat King sheet as a means to hold down the corners (think mattress pad concept with elastic straps)

[Doreen]

Thank you Bob. That’s a fabulous idea!