Axxera Radio has no power

[MaPatrick]

I have a 2018 Thor hurricane 31s Class A after storing it all winter went out and no power to the radio slash camera's I can't find in any documentation where the fuse is located at ? It's on a Ford Chassis and it's a Axxera Radio there is a spot on the face that say's Reset but I pushed a pin in it and no luck

[16ACE27]

Originally Posted by MaPatrick

I have a 2018 Thor hurricane 31s Class A after storing it all winter went out and no power to the radio slash camera's I can't find in any documentation where the fuse is located at ? It's on a Ford Chassis and it's a Axxera Radio there is a spot on the face that say's Reset but I pushed a pin in it and no luck

Status of House batteries?
Status of house battery disconnect (USE/STORE switch)?
RESET has to be held for 30 seconds and only works if the radio has power.

[Chateau_Nomad]

There's an inline fuse behind the unit. You might be able to get at it from under the dash... otherwise you'll have to pull the unit from the dash.

[MJC62]

Check the obvious boxes first. As Ace said radio is powered by the house batteries. Are they charged after winter storage? Has the use store switch been turned back to the use position? If the radio worked prior to storage, it is not likely the fuse blew when the radio sat not being used in storage.
On our ACE the use/store switch sits right next to the overhead lights and my wife has a tendency to hit the wrong switch when turning on the lights. We don't notice the switch has been tripped till we unhook from shore power.

[mgironwood]

Originally Posted by Chateau_Nomad

There's an inline fuse behind the unit. You might be able to get at it from under the dash... otherwise you'll have to pull the unit from the dash.

I have same problem. Batteries charged. Switch in use position. Have done reset. You mention fuse behind radio. Are there any other fuses I should check before climbing under dash. Was going to slide radio out but I cannot get front plastic trim on radio to pop. AV615BHM radio model

[MaPatrick]

Found it the reset had to be used with a paper clip it was so small I could hardly see the hole

[MaPatrick]

I found the problem it was the reset thanks

[Snicker]

So to clarify, the display was complete back and simply holding the reset switch in with a paper clip fixed it?

[16ACE27]

Originally Posted by Snicker

So to clarify, the display was complete back and simply holding the reset switch in with a paper clip fixed it?

That's the way it works.