Forgot to check for slide obstructions
All hooked up and ready to extend the bedroom slide, confirmed outside clearance was good, DW pushes Extend and slide goes out about 10 inches and comes to a halt and cocked sideways. We both did not notice the left closet door had opened thus jamming itself behind the right side of the bed wall..Ok so lets try and retract and start over, no response from the motors. Gee, not a good way to start a weekend! But thanks to having seen previous posts on slide problems I knew I could reset and re-sync the schwintex slide.
Now the hard part.. Thor had installed the slide controller behind the storage compartment wall but too far from the access panel making it impossible to push the reset button. Time for a cup of coffee and a Camel...Now I crawl in and blindly find the 1 screw holding the controller box and remove it so I can move it where it needs to go for easy access. Push the button 6 times then hold for 3 seconds on the 7th time and back in business.. Now We can retract. After 4 times extending about 12 inches and retracting it is back in sync. The obvious lesson here is look before you push but secondly fix those little Thor design issues before they bite you. I had previously seen that the controller was in a bad spot and put moving it on my list of things to do.... Now I can add "put a latch on closet door" to that list.
__________________
Steve and Rebecca
2 Golden Retrievers - Sydney and Brigid
Black Mountain, NC
Current coach: Itasca Navion IQ 24V
Former coach: Thor 22FE
|