LCI Leveling

[tfries]

Hello,

I hope all are well

When I turn on my LCI Control panel the left and Rear arrow key are lit, Is there a reset.

When I perform auto level my right front does not extend all the way, Has any one had this issue?

[16ACE27]

Those arrows light because the controller is telling you those sides are low and need to be raised to be level.

You may need to recalibrate your level position per the operators manual.

[rudyhehn]

The lights are on because the system senses you are not level. We parked on a firm surface and used a carpenters level on the floor and manually leveled the rig. Then we did a reset per the owner's manual. I think we had to hold three buttons down for three seconds, something like that. Then the system reset what it sees as level.

However ultimately we gave up on autolevel. It usually put us too far off the ground.
Instead I manually level it using bubbles that I stuck onto the front and side of drivers dash area. That works better and is very easy.