Bedroom Slide

[Grumpy Grampa]

Need help. Bedroom slide want open.

2017 Miramar 37.1.

Thank you

[Judge]

Need a little more info.....

- Does it make any noise?
- Do the other slides work?
- What type of slide mechanism?
- Is the coach level (so no binding)?

[Grumpy Grampa]

1. Unit level
2 other two slides work
3 Lippert

[Grumpy Grampa]

No noise, want even activate once I try to extend

[Judge]

Do you know where the controller is located for that slide? I would check to make sure it has power and also for possible error codes.

I'm not sure of each slide on your coach has its own 30A slide motor fuse but if so, I would check the fuse for that slide.

[Judge]

Originally Posted by Grumpy Grampa

No noise, want even activate once I try to extend

Then it sounds like it is not getting power. Check the 30A fuse or your specific slide motor fuse and check the controller for the LED's flashing an error code.

[Grumpy Grampa]

Found controller, no lights flashing.

Know I need to find 30 amp fuse, any thoughts for location on 37.1 Miramar?

Thank you

[Judge]

I don't have your coach but it should be with the other 12V fuses in the power distribution panel.

[Grumpy Grampa]

1. 30 amp main fuse is ok.
2. All 15 amp fuses ok.
3. Other two slides work.
4. Nothing flashing at controller.

[Judge]

Do you have a meter?

I would check the two leads that plug into the controller that provide 12V to make sure you do have power at the controller.

If you do have power, I would pull the negative lead... wait 30 seconds... then plug it back in to reboot the controller.

[Grumpy Grampa]

I check all controllers. The only one that is flashing red. Is my overhead bunk, and the key to activate is off?

[Grumpy Grampa]

Thank you all. I fell like such a dummy. The controller white wire was unplugged. Some how came off. I might have hit it, since it’s in the bay with 50 amp cord. Probably rolling it back in I bumped it.

Thanks again for all the advice.

[MJC62]

Originally Posted by Grumpy Grampa

Thank you all. I fell like such a dummy. The controller white wire was unplugged. Some how came off. I might have hit it, since it’s in the bay with 50 amp cord. Probably rolling it back in I bumped it.

Thanks again for all the advice.

Operator error is always an easy fix! Glad you found it

[16ACE27]

Under 2 hours from problem to fix! New World Record??

[Chateau_Nomad]

If there were blue ribbons for doing dumb stuff, I'd have a wall full! . But that's my learning process...