Bedroom slide out

[kneival]

I cannot get my bedroom slide out to work on my Thor Tuscany 45 LT. Does anyone have any suggestions on how to get my slide out? I have checked circuit breakers and tested to see if there is juice and those things are good?

[Grumpy Grampa]

Good morning. Does it do anything, when holding down the retract or extend button?

[kneival]

No it doesn’t.

[Grumpy Grampa]

A few things to check.

Make sure vehicle is in park.
Make sure coach batteries have a good charge.
If you can plug into shore power.

If none of those things work.

Locate slide controller, see if you are getting an error message, with Lippert is red lights flashing. Lippert has a chart so many red flashes indicates what error you have.

Good luck keep us posted.

[kneival]

There is no current going into the module. I cannot find a breaker switch between the control module and the breaker panel. I’m going to put a fused line to put current to the control module.

[kneival]

13398-C2 dual motor synchronous velocity slide controller is what I have.

[abjbrtd]

Post #6 in this thread may be your problem, or a good place to start looking

Link broken ?

Let us know

[kneival]

Originally Posted by abjbrtd

Post #6 in this thread may be your problem, or a good place to start looking

https://www.thorforums.com/forums/ne...reply&p=333495

Let us know

That is the controller I have but it doesn’t flash any red or green lights like the video I just watched. Any other suggestions?

[abjbrtd]

I'm having a problem linking threads, copying and pasting

This looks better, NOTa link.

"01-31-2022, 04:05 PM* #6

Bill in Redlands

Senior Member

*

Brand: Thor Motor Coach

Model: Axis 24.2

State: California

Posts: 129

THOR #18202

I found the problem between the two stowage areas under the slide. Three wires pass thru the areas and under the floor between them. They have been ripped apart right at the point they exit the first stowage area toward the second. I can't imagine the force that would require but can only assume it was the result of something snagging the wires as it was pulled out. The wires ripped at the point they pass through the wall of the stowage area which is rather sharp.

Each wire is the same type so it will be a challenge to figure out which pairs match up.

Attached Thumbnails

*****

**

******"

[Taysmom50]

Might check to be sure it somehow accidentally didn’t get put in storage mode. Has happened to me.

[kneival]

I replaced the controller and it works great!

[Jimbo56]

Originally Posted by kneival

I replaced the controller and it works great!

Thanks for following up to let us know you got it fixed.