camper trim

[Sivymp1]

Any idea how to fix this? Don't want to just cut it off. Sorry did not realize it was upside down. My camper is not on its top.

[JamieGeek]

I had that happen frequently with my 5th wheel.

You can squeeze it and push it back into the rail--you may have to pull some out to get enough slack for it to fit around the curve. Its best to do that on a warm day.

[Bob Denman]

I'm not very skilled at these types of repairs...
But I agree with Jamie... with perhaps the addition of a drop or three of your favorite adhesive.
Good luck!

[blw2]

it's just vinyl trim insert that slides into the aluminum trim.
It was likely put in a bit too tight and shrinkage causes it to pull out. I'd go all the way to the end of the strip, it is likely folded over under itself with a screw to pin it. Take that screw out to see if you have any slack.
otherwise, just replace the whole span of it. It's cheap....and it would give you a chance to inspect all the screws under it.... easy job.
https://www.etrailer.com/RV-Exterior...BoC_QgQAvD_BwE

[revjeffrey]

Warm it up with your hair dryer first.

[Sivymp1]

Yea I have tucked it in and it just pops out. Maybe I will just replace it. Looks like it is cheap to buy. Thanks.

[Bob Denman]

Good luck! Please show us some pictures of the completed project!

[rfd2117]

Same thing happened to us. Went to check on it this winter and it had poped out. Waited until a good warm day and just squeezed back into place. I will probably add a little adhesive when it gets warmer out so it'll stay in place.