Update: solenoid swap-out complete
Ok
Job is done
Here’s a few photos of the after photo, along with the corroded solenoid
I haven’t worked on it yet, but assume that once I clean it up it’ll be fine as a back-up
- Photo1 is the newly installed. Battery cable on one side, Converter cable on other. Two front connectors are for the switch wiring
- Photo2 is the old non-working Thor OEM
- Photo3 is the non-working corrosion. When in USE…the two posts are connected by the disk. But because of the corrosion, will not stick in place
__________________
'17 Vegas 24.1
Fallbrook, CA
|