Making some progress.
I installed my new Progressive Dynamics converter today.
Took about 3 hours.
The lugs for the battery connections on the circuit board are facing 90 degrees different from the old WFCO circuit board. It took a lot of maneuvering to get those wires bent so that the new circuit board would go back in to the power center. Also, with the Power Center at floor level, it was just a pain in the neck.
I was often blowing a 110 circuit breaker when my wife plugged in her hair dryer in the 110V outlets on the slide side of the house. Turns out that Thor connected the wire for the slide 110 V power to the same breaker as the convertor.
So, Today I noticed that there is an empty slot in the power center. I am going to buy another breaker and put it in the slot.
BTW, when I started this project today, my poor batteries were sitting at 5.2V. Next step is to get batteries.
Rick
__________________
2021 Outlaw 29S.
|