Hurricane 29 M Lippeet Slide Mod

[Gbland7424]

2017 Hurricane 29M Lippert Slide Module above driverseat is flasing red lights. 7 or 8 times then 1 green.

Slide is working fine, Cause for concern???

[halfprice]

Originally Posted by Gbland7424

2017 Hurricane 29M Lippert Slide Module above driverseat is flasing red lights. 7 or 8 times then 1 green.

Slide is working fine, Cause for concern???

Double tap the raise button for the over head bunk. The controller for the slide is in the rear driver side cargo bay

Jerry

[Mlleml]

Originally Posted by Gbland7424

2017 Hurricane 29M Lippert Slide Module above driverseat is flasing red lights. 7 or 8 times then 1 green.

Slide is working fine, Cause for concern???

Same thing happened to my Windsport 29M on both the drop down bunk and the slide. For the bunk, the right side was slightly lower resting on the safety pin. I raised the bunk, held the switch for 5 secs and error code gone. Sounds like the counts on the motors get mismatched, hence the code. On the slide, I hit retract then extended the full amount, again held the switch for the required 5 seconds and no more error. When I hit retract, I heard the motor run for just second do am guessing again it was slightly off-count from the other motor. Make sure you always extend/retract the full amount and always hold the switch for 5 secs after the move is complete.

[Lt Keefer]

Mine did that as well, reset the overhead bed, lights out.