LCI "ERROR" On leveling jacks

[roughinitrv@gmail.com]

Originally Posted by kequeen

I called Lippert they said if display went out to disconnect the red wire from the controller in the basement. If this doesn't work said I needed new display ordered a new display from Amazon ($30.00) cheaper than direct from Lippert ,solved the problem

Can you possibly send me a link to where you found this display for $30 on amazon? I am looking everywhere and it is $300.

[cruzin101]

Where is the breaker located in the battery compartment??

[Metalman]

Nearly since we purchased our 2015 Windsport in 2015 (used), we've been having error messages on the leveling system. Eventually the control panel in the cockpit failed and I purchased a new one for over $200. Now, I am still getting error messages when I start the engine, but after pressing the "cancel" and "enter" buttons and then turning off the leveling system, I am good to go. Anyone else getting the erroneous error messages? The system works fine otherwise.

[THOR TEAM]

If you still need your concerns to be addressed, we have a great Customer Service team you can reach at 877-855-2867 or you can email us at warrantysupport@tmcrv.com and we will gladly address your concern.

[Metalman]

Originally Posted by THOR TEAM

If you still need your concerns to be addressed, we have a great Customer Service team you can reach at 877-855-2867 or you can email us at warrantysupport@tmcrv.com and we will gladly address your concern.

Thanks for the information.

[FEZ]

Is Thor answering emails? I've sent two emails to two separate emails over the last two weeks with no reply at all. Thanks!

[Metalman]

I sent an email last week and got a reply, then sent another and no reply. Perhaps I will hear from them this week. I tried the "chat" session, but it was off line on Friday.

[FEZ]

Thanks Metalman! I just sent another email to them this morning, fingers crossed.

[Travelin' Texans]

Originally Posted by Metalman

I didn't realize there was a voltage readout on the LCD display. However, I was told by a tech at LCI that leaving the RV plugged in or on a charger will not necessarily provide enough current at startup to operate the levelers. He told me to start the engine and let it idle for a few minutes before operating the levelers.

If plugging into shore power or using a battery charger doesn't work you have other problems as well as the level up display.
If plugged in, with Use/Store switch in Use your batteries should be charging all the time when they need it unless your converter has quit. If a battery charger won't charge batteries then your batteries are toast. Your batteries may or may not be able to charge with the engine running, but with your engine alternator it could take several miles of driving or lots of idling to charge them. If your dealer told you this BS find a different dealer cause what they've told you is wrong.