LCI Jacks will not retract
This post is for info only.
Our jacks on our Outlaw 29S would not retract this morning. After reading the documentation, I opened all 4 cylinders. Still nothing worked. All the lights were flashing on the controller except the low voltage light.
After 2 hours of working on the issue, I called tech support.
They said to hold down all 4 directional buttons at the same time. That cleared up the monitor.
Still the jacks would not retract.
The technical support person said to check the high amp circuit breaker near the house batteries.
The breaker was attached along with other breakers to under side of one of the frame bars near the battery.
I discovered the 100 amp breaker was blown. The breaker looked like a little "flag" was raised from the breaker.
I pushed the "flag" back down and the breaker was reset.
The jacks retracted.