night shade

[racer]

just beeps when trying to lower or raise it any ideas

[Bob Denman]

That's got to be a warning of some sort...
Have you tried to lower them, and had someone gently give a light pull on them to help them get moving?

[racer]

yes i tried that just beeps trying to go either direction

[Lt Keefer]

Try starting up the coach and shifting it into gear and then back to park. You may have an interlock that is sticking.

[Pete'sMH]

When mine did that I reasoned that the beep meant it was stuck in programming mode. Try pushing the programming control button a time or two. You’ll probably have to reprogram from start but it’s not hard. It worked for me, anyway.

[racer]

where is the programming control button?

[rudyhehn]

The shade has a controller board under the dash that prevents the shade from dropping while the engine is running. On my RV my shade failed and would not go either direction, but did not beep. I checked the switch with a meter, and it worked. I had to call the shade folks and order a new control board. I replaced it and that solved the problem. BTW the board is way under the dash, a bitch to reach.

[Pete'sMH]

Originally Posted by racer

where is the programming control button?

On mine it is on the end of a pigtail tucked up on one end of the shade. It’s just a button on the end of a couple of wires. Of course, your shade and wiring may be different from mine so no promises.

[Lt Keefer]

Originally Posted by Pete'sMH

On mine it is on the end of a pigtail tucked up on one end of the shade. It’s just a button on the end of a couple of wires. Of course, your shade and wiring may be different from mine so no promises.

Same with mine. It hangs down from the left end of the roller.

[ducksface]

Instructions on

[PaulH]

Thanks, mine stops too high when driving. I'll give it a go.

[rudyhehn]

Mine has two allen screws that set the top and bottom stop points.