Removing side “tables”

[WearyTraveler]

I’m trying to tighten the table up. It wiggles pretty badly. I can find 2 exposed screw heads (one on each end of the “table”). When I loosen them and pull away from the wall I see what appears to be 2 screws that the heads are either inside the “table” or they’re heads are outside and screwed in.
The 2 “inside” screws I’m referring to are below my finger and thumb.

Any suggestions?

Thank you in advance!

I took out the cup holder. There are 3 screws holding a metal bracket to the wall and the table is attached to the bracket. The screw holding the top of the bracket is stripped so the bracket wiggles and so does the table.

If I can remove the leveling control panel I probably can remove the table and gain access to fix the metal bracket.

Any suggestions about removing the leveling panel?

[Bratmanstudio]

Thor Miramar? Mine looks the same, that plastic not-quite arm rest is really on a metal piece that is screwed into the wall and comes off the metal easily with two screws, but be careful as it's a flimsy piece of plastic and has wiring going to the switches and leveler jacks stabilizer unit. Be gentle removing the plastic arm cover, it can hang by the wires, make sure the screws in the metal frame are not stripped in the wall, tighten the metal, replace the plastic and should be good. I removed mine to replace the mirror heater switch and to install a break light led for my ready break elite system.

[WearyTraveler]

Yeppers - I discovered that right after my initial post.

Damn - Thor QA sucks...

[WearyTraveler]

Got the table off. Of the 5 screws holding the bracket to the wall 4 were loose and one was stripped.

Again - Thor QA is lacking.