Monitor Panel not reading levels

[frschof]

The monitor panel for thor fourwinds 2013 not reading the batt, lps, fresh black and grey. Just the red emply light for all the above. I know there should have been readings from i.e. filling the fresh tank light indicated E empty. ect. All other switches on the panel work. i.e. hot water tank, Genny on and off.
tks in advance
Frank

[Tailgunner]

My 2010 just did the same thing. It turned out to be the motherboard that control them went bad.

[frschof]

Do you have still have the info for ordering a new module for the monitor.? appreciate any info tks.

Frank

[javelin]

I am not sure if the attached link to Ventline Monitor Panels information (now owned and branded by Dexter), will be of any help to you or not, but there is a section in the information for troubleshooting typical problems with these monitor panels. It might help you to check that your +12vdc and grounds are good to the panel first and then the wiring to the specific sensors and finally the circuit board.



https://www.nroa2003.com/download/Ow...tor-Manual.pdf

[frschof]

THe small 3x2 inch card inside the monitor panel was replaced for about 25.00 works fine. thanks for all your helpl

[frschof]

That board did the trick. thank you for the info.

[Tailgunner]

Ordered mine from Thor.