I have finally found the water leak under the bed. The pump is leaking up front.
It's been driving me crazy. It seemed to only leak with the pump on, however today I found it leaking with pump on/off.
I'm about 1/2 done moving the wiring so I can get to the pump. I think it may be a bad seal but thinking just get a new pump.
Any suggestions on what/where to buy?
I'm thinking about shorting all the wiring so the next time I need to do anything under the bed I will be able to see the components. There's probably over a 100 wires that could be shorten and reconnected, It's supposed to be 95+ today high humidity so I'll probably delay the wiring till fall when it cools down.
I finally got the pump out, I noticed that there was crud right at the imputes fitting. I had tighten it a couple months ago thinking it was loose. Once I cleaned the crud I found a hair line crack, maybe froze at some point. At least I know I need a new pump.
Now to which one, the bulk of what I'm seeing are 3.5GPM the pump that I took out is a 3 GPM 40 PSI.
Will a 3.5 be too much?
I'm thinking 3.5GPM and 45 PSI won't strain the system